Servo Motor Repair Workshop

Servo Repair Workshop

Our dedicated servo motor repair workshop has all the modern tools and equipment needed to carry out a successful servo motor repair.

Assessing Bench

Here the servo motor is first assessed to find out what is wrong.

The feedback sensors are checked and alignment is recorded.

If there are no winding or contamination faults the motor is ‘off load’ run tested.

Servo Repair Workshop - Assessing Bench

Stripping Benches

The servo motor is stripped into component parts.

Each bench is equipped with all the mechanical tools required to strip the motor.

All mechanical parts are checked for fit and tolerance.

Servo Repair Workshop - Stripping Bench

Cleaning Stations

All parts of the servo motor are cleaned to remove grease, oil, cutting fluid or any other contaminant found.

We use a variety of cleaning stations that best fits the requirement. Vaqua blast, ultrasonic tanks, rotary wash tanks and solvent clean tanks.

All the parts are then dried in our temperature controlled ovens.

servo-repair-workshop-cleaning-station

Feedback Sensor Repair Bench

We use a number of our own designed and propriartory test pieces to check the operation of incremental and absolute encoders, resolvers, hall effect sensors, serial encoders and memory devices. We also use the Mitchell TI5000EX.

Feedback Sensor Repair Bench

Rotor / Armature Balancing

Each rotor or armature from a servo motor is check balanced against a standard tolerance.
All mechanical reclamations i.e. keyway repairs, bearing housing or journal repairs, are carried out in our fully equipped mechanical workshop.

Rotor / Armature Balancing

Servo Motor Testing

We light run test all servo motors when the repair has been carried out. The feedback sensor alignment is set or programmed and the motor is tested ‘off load’ to check for operation. We use a variety of our own designed test rigs, manufacturers drives and the Mitchell TI3000 to run the servo motor prior to the full load test being carried out.

Servo Motor Testing

Assembly Benches

Once all parts are serviced the servo motor is assembled using special tools required for servo motor assembly.

The brakes are fitted and set, the feedback sensors are assembled and set and the motor is ready for the first in a series of final tests.

Assembly Benches

Servo Motor Testing

We light run test all servo motors when the repair has been carried out. The feedback sensor alignment is set or programmed and the motor is tested ‘off load’ to check for operation.

We use a variety of our own designed test rigs, manufacturers drives and the Mitchell TI3000 to run the servo motor prior to the full load test being carried out.

Servo Motor Testing